Toyota Rear Link Kit



We have heard from a lot of people wanting to only link their rear suspension so we created a kit using the back half of our full link kit. You still get all of the benefits of our subframe and removable skid plate design but you have to do a little more work to get it. We provide you with the hard part of the removable skid plate where it ties into the rear of the subframe and rear lower link brackets, you just need to continue the skid plate forward to connect to your transfer case crossmember.
The kit includes everything you need to link the rear of your truck other than shocks/springs, upper shock mounts, bump stops, and limit straps. Link tubes are provided extra long and will allow the rear axle to be pushed back up to 6”
The bottom of the subframe hangs 5” below the frame rails which is about the same as most aftermarket transfer case crossmembers. Because of this you get great anti-squat/roll axis geometry and unlike other kits on the market you do NOT have to cut your floor/bed out to make room for the upper link mounts.



Includes the following parts:
1  Rear subframe with removable center section/frame end link mounts
2  Rear axle lower link brackets
1  Rear axle upper link bracket assembly
2  Rear lower shock mounts
4  1 1/4" Ruffstuff chromoly heim joints with misalignment spacers/jam nuts/tube bungs
4  7/8"   Ruffstuff chromoly heim joints with misalignment spacers/jam nuts/tube bungs
2  lower link tubes
2  upper link tubes
1  Grade 8 hardware kit



Important notes about this kit:
-Requires relocating your gas tank

There are no articles in this category. If subcategories display on this page, they may contain articles.

Custom work performed on:

Rock crawlers
Street Rods
Most other vehicle or non vehicle metal fabrication

Services include:

Assembly and installation of our products
Welding (MIG only)
Tube bending
Roll cages
Plasma cutting
Vehicle fluid system plumbing
Vehicle preparation
Custom suspension design and fabrication
General metal fabrication
Please Contact us for details.

Custom fabrication and product installation is available on a limited basis. Please Contact us for details.